检索结果分析
成果/Result
成果类型
- 期刊论文
- 学位论文
- 专利
- 会议论文
- 科技成果
- 标准
- 专著
- 产品
- 科技报告
- 政策法规
- 内部文献
- 报纸
- Comprehensive error measurement and compensation method for equivalent cutting forces
- INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGYShi, Xianli Liu, Huanlao Li, Hao Liu, Can Tan, Guangyu 出版年：2016
- To determine the error compensation for cutting forces with a machine tool, this paper proposes a comprehensive error compensation method that determines an equivalent cutting force. The loading system that applies this ...
- Frequency-spectrum characteristics of force in end milling with tool wear and eccentricity
- INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGYLiu, Can Wu, Jing-quan Li, Guang-hui Tan, Guang-yu 出版年：2013
- The effects of chip load, tool wear, and tool eccentricity on milling force are similar; in order to distinguish them from each other, the spectral characteristics of milling force for four flute end mills was studied. W...
- Improved Hybrid Grey Wolf Optimization Algorithm Based on Dimension Learning-Based Hunting Search Strategy
- IEEE ACCESSZhang, Chuanjing Liu, Huanlao Zhou, Qunlong Liu, Can 出版年：2023
- An improved hybrid grey wolf optimization algorithm (IHGWO) is proposed to solve the problem of population diversity, imbalance of exploration and development capabilities, and premature convergence. The algorithm benefi...
- Geometry features of breakage section and variation of cutting force for end mills after brittle breakage
- INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGYLiu, Can Wu, Jing-quan Liu, Huan-lao Li, Guang-hui Tan, Guang-yu 出版年：2016
- Some broken end mills with many brittle breakage sections were collected, and the geometry features of these sections were summed up. As for minor breakage, the breakage sections were narrow planes parallel to the tool e...
