文献类型：期刊文献

英文题名：Experimental study on adhesive wear of milling insert with complex groove

作者：Tan, Guangyu[2];Liu, Guangjun[1];Li, Guanghui[2]

机构：[1]Tongji Univ, Coll Mech Engn, Shanghai 200092, Peoples R China;[2]Guangdong Ocean Univ, Coll Engn, Zhanjiang 524005, Peoples R China

年份：2009

卷号：44

期号：7-8

起止页码：631

外文期刊名：INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY

收录：SCI-EXPANDED(收录号：WOS:000269434300001)、、EI(收录号：20093712299811)、Scopus(收录号：2-s2.0-69649096747)、WOS

基金：The authors would like to acknowledge the support of the National Science Foundation of China (50575062), the Specialized Research Fund for the Doctoral Program of Higher Education (20060214002), and the Key Project for Abroad Scholar of Education Department of Heilongjiang Province (1151HZ003).

语种：英文

外文关键词：Adhesive wear; Milling insert; Complex groove; Stainless steels

外文摘要：This paper presents an experimental study on the adhesive wear of a milling insert with complex groove when milling 3Cr-1Mo-1/4V and 0Cr18Ni9 steels. Experimental measurements of milling temperature and milling force were performed. Then the adhesive behaviors and mechanisms between the steels and uncoated carbide were analyzed and discussed. It is found that the high temperature gradient, thermal stress, alternate compressive stress, and tensile stress in cut-in and cut-out, provide a situation for adhesion. Some suggestions for avoiding adhesive wear and the mechanism of adhesive wear of the insert are presented.